23 00 037 Installing replacement transmission (GS6-53BZ/DZ)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, check TRANSMISSION FLUID LEVEL .
Use only the approved transmission fluid. See MANUAL TRANSMISSION - OPERATING FLUIDS .

Failure to comply with this instruction will result in serious damage to the transmission.

Recycling:

Catch and dispose of escaping transmission fluid.

Observe country-specific waste-disposal regulations

Necessary preliminary tasks:

Drain gear oil at oil drain plug. Tightening torque: 23 00 4AZ .
REMOVE TRANSMISSION .

If necessary, unfasten screws.

Remove and convert transmission bearing block.

Tightening torque 22 32 2AZ .

NOTE: Illustration shows E46.

Fig 1: Locating Transmission Support Block Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Convert shift rod joint.

Push back retaining ring (1) and drive out dowel pin (2).

Fig 2: Driving Out Dowel Pin

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check damping disk (6) for damage and replace if necessary.

Fig 3: Identifying Damping Disk

Courtesy of BMW OF NORTH AMERICA, INC.

Convert following parts from previous transmission to new transmission.

RELEASE BEARING AND RELEASE LEVER .
Ball pin and spring wire clip
Studs for clutch slave cylinder.
Reversing light switch tightening torque: 23 41 5AZ .

Add final details to vehicle.

Check oil level.

Installation: