17 11 035 Replacing fan cowl with electric fan

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Switch off ignition

Necessary preliminary tasks:

Lay coolant line (1) over engine.

Fig 1: Laying Coolant Line Over Engine

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Fig 2: Unlocking Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip left lines (1) at lower section of fan cowl from holder.

Fig 3: Identifying Left Lines At Lower Section Of Fan Cowl From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Pull clip (1) on holder (2) in direction of arrow and slide down holder (2) in direction of arrow.

NOTE: For purposes of clarity, this work step is shown with the component removed.

Fig 4: Pulling Clip On Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip right lines (1) at lower section of fan cowl from holder.

Fig 5: Identifying Right Lines At Lower Section Of Fan Cowl From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Slide screwdriver (1) under holder (2) and press towards radiator. At the same time slowly slide holder (2) under in direction of arrow.

NOTE: For purposes of clarity, this work step is shown with the component removed.

Fig 6: Sliding Screwdriver Under Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through cable tie (1).

NOTE: For purposes of clarity, this work step is shown with the component removed.

Installation:

Replace cable ties.

Fig 7: Identifying Cable Tie

Courtesy of BMW OF NORTH AMERICA, INC.

Remove fan cowl (1) in direction of arrow.

IMPORTANT: Set down fan cowl in upright position, otherwise oil will escape from engine oil cooler.

Fig 8: Removing Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: After completing work, check engine oil level and top up if necessary.
Check function of DME.