72 11 102 Removing and installing/replacing all rear seat belts

Necessary preliminary tasks: 

• Remove PANEL FOR REAR WINDOW SHELF
• Remove REAR SEAT

Removing left and right inertia reel units: 

Release screw (1) on left and right inertia reel units (2).

Tightening torques 72 11 20AZ

Remove left and right inertia reel units (2).

Removing middle inertia reel unit: 

Unscrew bolt (3).

Tightening torques 72 11 20AZ .

Remove inertia reel unit (4).

Installation: 

Guide lug of inertia reel unit (4) must be correctly seated in opening in body.

Fig 1: Identifying Screw, Inertia Reel Units And Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Pay attention to coding on inertia reel unit (1) and on body (2).

Fig 2: Identifying Inertia Reel Unit And Body

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2) on left and right.

Tightening torques 72 11 22AZ .

Remove left and right seat belts (1).

Installation: 

Secure fittings of left and right seat belts (1) through guides (2) and stop (3).

Fig 3: Identifying Screws And Seat Belts

Courtesy of BMW OF NORTH AMERICA, INC.

Removing lower strap receptacles: 

Release screws (1).

Tightening torque 72 11 23AZ .

Remove lower strap receptacles (2).

Remove middle upper strap (3).

Fig 4: Identifying Screws, Lower Strap Receptacles And Middle Upper Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Ensure correct installation sequence and installation position:

• Fittings of center lower strap/center upper strap must rest on stop (1).
• Secure lower strap on left and right through guides (2).
  Fig 5: Identifying Stop And Guides

  Courtesy of BMW OF NORTH AMERICA, INC.