61 13 040 Replacing distribution box (passenger compartment)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe SAFETY INSTRUCTIONS for handling vehicle battery.

Necessary preliminary tasks:

Remove LUGGAGE COMPARTMENT TRIM ON SIDE PANEL ON RIGHT
Disconnect negative battery cable
Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT
Remove RIGHT GLOVEBOX WITH HOUSING

Release screws (1) and remove distribution box (2).

Fig 1: Identifying Distribution Box And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect all plug connections (1).

Unlock relay base (3) and disconnect.

Open cover (2) on positive battery cable and release nut underneath.

Tightening torque 61 21 2AZ .

Disconnect positive battery cable from distribution box.

Fig 2: Identifying Relay Base And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure positive battery cable is correctly seated on fuse box.

Replacement:

Remove fuses.