63 12 010 Removing and installing/replacing left headlight (xenon headlight)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow instructions for handling light bulbs (exterior lights) .

Unclip strip (1) in direction of arrow.

Release screws (2) underneath.

Fig 1: Uncliping Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Turn cap (1) approx. 30° counterclockwise and remove from headlight (2).

Fig 2: Turning Cap For Removing

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1)

Unfasten screws (2).

Installation:

Observe gap dimensions . See 41 00... BODY GAP DIMENSIONS .
Adjust headlights

Fig 3: Identifying Screws
Courtesy of BMW OF NORTH AMERICA, INC.

Pull bumper panel (1) forwards slightly and feed out headlight (2) in direction of arrow.

Installation:

Make sure headlight (2) is correctly seated in lower holder.

Unlock and disconnect associated plug connections (3).

Remove headlight (2).

Fig 4: Pulling Bumper Panel And Feeding Out Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unclip headlight holder (1) and remove.
Remove ignition unit and bulb for xenon headlight (2)
Remove control unit for xenon headlight (3)

Fig 5: Identifying Headlight Holder, Ignition Unit And Bulb For Xenon Headlight
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs (1) on headlight holder (2) must not be damaged.

Make sure headlight holder (2) is correctly engaged on headlight.

Fig 6: Identifying Lugs On Headlight Holder

Courtesy of BMW OF NORTH AMERICA, INC.