63 12 860 Replacing control unit for left xenon headlight

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.

Necessary preliminary tasks:

Remove LEFT HEADLIGHT .

Build date up to 03/07:

Release screws (1).

Remove control unit for xenon headlight (2) from headlight (3).

Fig 1: Identifying Screws, Control Unit For Xenon Headlight And Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Build date from 03/07:

Release screws (1).

Remove control unit for xenon headlight (2) from headlight (3).

Fig 2: Identifying Screws, Control Unit For Xenon Headlight And Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

When installing control unit for xenon headlight (1), make sure sealing sleeve (2) is correctly seated.

Fig 3: Identifying Xenon Headlight And Sealing Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.