52 24 408 Replacing backrest cover (basic) for left or right rear seat

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

52 0 050 . See SEATS - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove backrest for rear seat
Remove center armrest
Remove head restraint guides

Release clips (1).

Feed out cover in area (2).

Fig 1: Feeding Out Cover In Area

Courtesy of BMW OF NORTH AMERICA, INC.

Release clips (1).

Feed out cover in area (2).

Remove frame (3).

Fig 2: Identifying Frame And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding:

If necessary, mark retainer positions
Release all retainers in marked area
Remove cover from padding
Remove remaining retainers from cover and padding

Installation:

Insert new retainers with special tool 52 0 050 . In so doing, enclose wire in padding and trim wire of cover.

Fig 3: Remove Remaining Retainers From Cover And Padding

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover:

Pull all trim wires out of seat cover
If necessary, cut pockets in new cover for trim wires
Push trim wires into pockets

Fig 4: Pushing Trim Wires Into Pockets
Courtesy of BMW OF NORTH AMERICA, INC.