37 20 505 Removing and installing/replacing DYNAMIC DRIVE holder/valve block
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
Seal off pipe connections with plugs.
After installation:
- Fill and bleed hydraulic system . See 37 10 001 Initial operation with test run of Dynamic Drive .
- Check pipe connections for leaks
- If necessary, carry out initial operation for Dynamic Drive
Necessary preliminary tasks:
- Remove valve block
Release screws (1).
Tightening torque 37 14 20AZ . See INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES .
Take off holder (2).