34 11 519 Removing and installing/replacing left or right front brake caliper

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove wheels

OBSERVE SAFETY INSTRUCTIONS ON RAISING THE VEHICLE .

After completing work: BLEED BRAKING SYSTEM

Press clutch pedal down to floor and secure with pedal support.

NOTE: The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.

Fig 1: Pressing Clutch Pedal Down To Floor

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Removing Brake Caliper

Courtesy of BMW OF NORTH AMERICA, INC.

Left side: Disconnect plug connection for wear indicator.

Release brake hose on brake caliper.

Slacken connection for brake hose and brake line.

Installation:

Tighten brake hose on brake caliper.

Tightening torque 34 32 4AZ .

Move steering to straight-ahead position.

Screw brake hose to brake line, ensuring that brake hose is not twisted.

Tightening torque 34 32 1AZ .

Release screws (1) and remove brake caliper.

Installation:

Tightening torque 34 11 2AZ .