31 35 021 Replacing rubber mounts of stabilizer retaining fixture on front axle carrier
WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove stabilizer from front axle carrier . See 31 35 000 Removing and installing/replacing front stabilizer or 37 11 010 REMOVING AND INSTALLING/REPLACING FRONT ACTIVE STABILIZER .
Remove retaining bracket (1), if necessary retaining plate (3) and rubber mount (2) on both sides.
Installation:
Keep retaining bracket (1), rubber mount (2) and stabilizer clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.