31 35 000 Removing and installing/replacing front stabilizer

WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front assembly underside protection . See 51 47 490 REMOVING AND INSTALLING / REPLACING FRONT UNDERBODY PROTECTION .
If necessary, remove wheel suspension cover on both sides
Remove stabilizer link on both sides from stabilizer

If necessary, remove holder for hydraulic lines from retaining bracket.

Release nut (1) and screw (2) at both ends.

Remove stabilizer from front axle carrier.

Installation:

Check both rubber mounts for damage, replace if necessary.

Replace self-locking nuts.

Tightening torque 31 35 1AZ . See 35 STABILIZER BAR .

Fig 1: Identifying Stabilizer Screw And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove rubber mount on both sides from stabilizer .