52 24 400 Replacing Seat Cover For Rear Seat

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

52 0 050

Necessary preliminary tasks:

Remove SEAT FRAME

Security version only:

Middle belt not fitted.

Remove trim (1).

Fig 1: Identifying Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding:

If necessary, mark seating of retainers
Release retainers in marked areas
Remove seat cover from padding
Remove all remaining retainers from seat cover and/or padding

Installation:

Feed cable through hole in padding
Insert new retainers with special tool 52 0 050 . In so doing, enclose wire in padding and trim wire of cover

Fig 2: Identifying Seat Cover
Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover:

Pull all trim wires out of seat cover
If necessary, cut in take-up for trim wires of new cover
Push trim wires into new seat cover

Fig 3: Identifying Seat Cover Trim Wires

Courtesy of BMW OF NORTH AMERICA, INC.