72 12 010 Removing And Installing/Replacing Airbag Module On Left Or Right Front Door
WARNING: This page is about a different car, the 2008 BMW 550i, 2007 BMW 550i, and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Front and rear airbag modules must not be mixed up.
Necessary preliminary tasks:
- Disconnect battery cable
- Follow instructions for disconnecting and connecting battery.
- REMOVE FRONT DOOR TRIM
Unfasten screws.
Carefully remove airbag module.
Installation:
Before installing airbag module, remove all foreign bodies (screws, etc.) from installation recess.
Replace screws.
Tightening torque: 72 12 01AZ . See AIRBAG MODULES for specs.
IMPORTANT:
Danger of mix-up with airbag module of rear door.
Difference:
- Coded plug
If the plug does not fit on the module, check whether a module was installed for the rear door.
- "VORN / FRONT" and "HINTEN / REAR" printed on