66 54 511 Replacing Night Vision Camera

WARNING: This page is about a different car, the 2007 BMW M5, 2007 BMW 550i, 2006 BMW M5, and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)

IMPORTANT:

New component contains a CD with deblocking code.

Deblocking code CD is requested during coding/programming by the SSS.

Coding/programming without the deblocking code CD is not possible!

Necessary preliminary tasks:

Remove NIGHT VISION CAMERA

Release screw (1) on both sides.

Remove camera (2) from holder (3).

Fig 1: Identifying Camera, Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert camera (1) in holder (2).

Left guide pin (3) must be correctly seated in holder (2).

Apply screw securing adhesive to screw (4) and tighten screw.

Fig 2: Identifying Camera, Holder, Guide Pin And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Tab (1) must snap noticeably into holder (2).

Make sure guide pin (3) is correctly seated in holder.

Apply screw securing adhesive to screw (4) and tighten screw.

Fig 3: Identifying Holder, Guide Pin And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carry out PROGRAMMING/CODING .
Adjust NIGHT VISION CAMERA