63 12 895 Replacing Drive For Left Adaptive Headlight

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

WARNING:

Version with xenon headlights: Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.

Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.

Necessary preliminary tasks:

Remove LEFT HEADLIGHT

Release screws (1).

Remove drive for adaptive headlight (2) from headlight (3).

Fig 1: Identifying Adaptive Headlight And Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit drive for adaptive headlight (1) exactly on headlight.

Make sure pin housing (2) is correctly seated in plug housing (3).

Fig 2: Identifying Pin Housing And Adaptive Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out PROGRAMMING/ CODING .