61 67 083 Removing And Installing/Replacing Left Or Right High-Pressure Nozzle Of Headlight Cleaning System
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Necessary preliminary tasks:
- Remove FRONT BUMPER TRIM
To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010
Unlock high-pressure line (1) and detach from high-pressure nozzle (2).
Release screws (3).
Remove high-pressure nozzle (2).
Installation:
New spray nozzles are already preset.
Carry out a function test before fitting bumper trim.