61 12 065 Replacing Wiring Harness For Front Bumper

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Read and comply with notes on HANDLING WIRING HARNESSES and cables.

Necessary preliminary tasks:

Remove FRONT BUMPER TRIM

NOTE:

Operation is shown by way of example on the E63 (build date up to 09/2007). There may be differences in detail in the case of other vehicle models.

Disconnect plug connections (1) on ultrasonic transducer.

Unclip wiring harness (2) from bumper trim.

Fig 1: Identifying Plug Connections And Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) in direction of arrow from bumper trim.

Remove wiring harness (2).

Installation:

Make sure wiring harness (2) is laid correctly.

Fig 2: Identifying Plug Of Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.