64 11 818 Replacing SERVODRIVE For Right Cold Air Duct (Automatic A/C High)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove servodrive for right hot air flap . See 64 11 813 REPLACING SERVODRIVE FOR RIGHT HOT AIR FLAP (AUTOMATIC A/C HIGH) .

Release screw (1).

Remove holder for servodrive for right hot air flap (2).

Fig 1: Removing Holder For Servodrive For Right Hot Air Flap

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Press lock (2) and unclip servodrive for right cold air duct (3) in direction of arrow.

Installation:

If necessary, align shaft of flap(s) to be actuated to position of servodrive to be installed.

Fig 2: Uncliping Servodrive For Right Cold Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.