51 13 282 Replacing Trim Strip On Roof Frame At Left Or Right

Special tools required: 

• 00 9 321 

Necessary preliminary tasks: 

• Remove trim strip from roof frame  . See 51 13 280 REMOVING AND INSTALLING TRIM STRIP ON ROOF FRAME AT LEFT OR RIGHT .

Lever out retainers (1 to 4) from trim strip (6).

A Direction of travel, front

5 Seal

Fig 1: Identifying Clips Or Seal Of Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out black retainer (1) from trim strip (6).

Installation: 

Clip black retainer (1) into bore on trim strip (6).

A Direction of travel, front

Fig 2: Identifying Clip Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out retainers (1 to 3) from trim strip (6).

Installation: 

Clip black retainers (1) into bores on trim strip (6).

A Direction of travel, front

2 Black retainers

3 White retainers (E65), black retainers (E66)

Rubber on retainers (2 and 3) must not be damaged or missing.

For position of retainers (2 and 3), refer to next step.

Fig 3: Identifying Clip Retainers

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Attach retainers (2 and 3) at distance (B) from hole (7).

A Direction of travel, front

B = 25 mm

Bore (7) for white retainers (3) is approx. 715 mm further back.

Fig 4: Attaching Retainers At Distance From Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out white retainer (4) from trim strip (6).

Installation: 

Clip white retainer (4) into bore on trim strip (6).

A Direction of travel, front

Fig 5: Identifying Clip White Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

All retainers must be removed in order for seal (5) to be removed.

Glue molded part of seal (5) to trim strip (6) with Loctite 454 (sourcing reference: BMW Parts Service).

Coat remainder of sealing channel of seal (7) with antiseize agent (50 % water / 50 % washing-up liquid).

Fit seal (7) and press into end position with special tool 00 9 321  (fishbone).

Fit seal (8) without antiseize agent in compressed state.

A Direction of travel, front

Fig 6: Identifying Glue Molded Part Of Seal And Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

New seals (7 and 8) are longer than trim strip (6).

After installation, compress seals (7 and 8) slightly.

Cut seals (7 and 8) to length at ends to trim strip (6).

A Direction of travel, front

Fig 7: Identifying Cut Seals To Length At Ends To Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.