35 11 000 Removing And Installing Mounting Block For Pedals

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Check the function after installation.

Remove panel for pedal assembly. See 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDAL ASSEMBLY .

Release screw (1) on footwell air duct. First pull footwell air duct to left, then remove towards bottom front.

Fig 1: Releasing Screw On Footwell Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retaining clip on brake pedal (1).

Withdraw pin.

Release nuts (2).

Installation:

Replace nuts (2).

Tightening torque . See PEDALS - TIGHTENING TORQUES - ALPINA .

Fig 2: Identifying Brake Pedal And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Remove brake light switch (1). See 61 31 310 REPLACING BRAKE LIGHT SWITCH .

Release nut (2) for brake pedal.

Installation:

Replace nut (2).

Tightening torque . See PEDALS - TIGHTENING TORQUES - ALPINA .

Fig 3: Identifying Brake Light Switch And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (1).

Pull out light module with holder towards front.

Pull off connectors.

Remove light module.

Remove bearing bracket for pedal assembly.

Fig 4: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position guide lug (1) precisely during installation to prevent damage.

Fig 5: Identifying Guide Lug

Courtesy of BMW OF NORTH AMERICA, INC.