51 45 030 Removing And Installing Instrument Panel Trim
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Move wheels into straight-ahead position
- Move front seats back completely and lower
- Retract steering wheel completely and lower
- Disconnect battery negative lead . See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
- Remove both trims for front roof pillar . See 51 43 201 REMOVING AND INSTALLING/REPLACING TRIM FOR ROOF PILLAR AT FRONT (A-PILLAR), LEFT OR RIGHT .
- Remove light operator unit . See 61 31 037 REMOVING AND INSTALLING/REPLACING LIGHT CONTROL UNIT .
- Remove side cover on instrument panel on left and right . See 51 45 ... REPLACING SIDE COVER ON INSTRUMENT PANEL .
- Remove trim panel for pedal assembly . See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
- Remove steering column switch cluster . See 61 31 008 REMOVING AND INSTALLING OR REPLACING STEERING COLUMN SWITCH CLUSTER .
- Remove instrument cluster . See 62 11 280 REMOVING AND INSTALLING (REPLACING) INSTRUMENT CLUSTER .
- Remove front speaker carrier . See 65 13 065 REMOVING AND INSTALLING/REPLACING FRONT SPEAKER CARRIER (INSTRUMENT PANEL) .
- Remove Car Communication Computer . See 65 83 010 REMOVING AND INSTALLING/REPLACING CAR COMMUNICATION COMPUTER .
- Remove Central Information Display . See 65 50 057 REMOVING AND INSTALLING REPLACING CENTRAL INFORMATION DISPLAY (CID) .
- Remove right fresh-air grille . See 64 22 135 REMOVING AND INSTALLING/REPLACING LEFT/RIGHT FRESH-AIR GRILLE .
- Remove trim for instrument panel, bottom left . See 51 45 181 REMOVING AND INSTALLING/REPLACING BOTTOM RIGHT TRIM FOR INSTRUMENT PANEL .
- If necessary, remove trim for head-up display . See 62 30 005 REMOVING AND INSTALLING/REPLACING TRIM FOR HEAD-UP DISPLAY .
Release screw (1).
Release screws (1).
Disconnect plug connection (1) for passenger airbag.
Release screws (2).
Release screws (1).
Unclip plate (1).
Release screw (1).
Disconnect plug connection (1).
Release screw (1).
Release screws (1).
Feed out instrument panel trim towards rear and remove.
Installation:
Make sure guides (1) of instrument panel trim are correctly seated in relevant mountings (2).