LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Body Equipment - Repair) >> 44 Roof Trim Panel >> 51 44 013 Removing And Installing/Replacing ROOFLINER (Version With Panorama Sunroof)

51 44 013 Removing And Installing/Replacing ROOFLINER (Version With Panorama Sunroof)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

Release screws (1).

Fig 1: Identifying Screws
G04791793Courtesy of BMW OF NORTH AMERICA, INC.

Version with roller combination (dividing net): 

Fold back cover (1) for dividing net mount (2).

Release screw (3) and remove dividing net mount (2).

Installation: 

Observe position indications on reverse side of dividing net mount (2).

Fig 2: Identifying Special Tool (00 9 323)
G04791794Courtesy of BMW OF NORTH AMERICA, INC.

Release expansion rivet (1).

Fig 3: Identifying Expansion Rivet
G04791795Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: The following tasks must be carried out with a second person assisting:

Support roofliner (1) at front.

Unclip roofliner (1) at clips (2) in sunroof frame area in downward direction.

Installation: 

If necessary, replace faulty clips (2).

Fig 4: Identifying Support Roofliner
G04791796Courtesy of BMW OF NORTH AMERICA, INC.

Detach rear lid mucket in area of roofliner (1).

Release clip (2) at roofliner (1) with fork lever from body roofliner.

Carefully tilt roofliner (1) and feed out towards rear.

Installation: 

Clip (2) and metal retainers in body roofliner must not be damaged, replace if necessary

Fig 5: Identifying Clip At Roofliner
G04791797Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Version with roller combination (dividing net): 

Cut out pre-marked cutout areas (1) for left/right dividing net mounts with a scalpel.

IMPORTANT: Ensure a clean cut so that the headliner material is not damaged on the inside.
Fig 6: Identifying Cutout Areas
G04791798Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Installation sequence:

  1. Secure roofliner with mucket
  2. Secure roofliner at front to clips
  3. Snap roofliner at rear into clip
  4. Secure expander rivets to roofliner at front
  5. Screw down grab handles at front on left/right
  6. Screw down grab handles at rear on left/right
  7. Screw down sun visors and counter supports
  8. Add final details to vehicle