65 50 631 Replacing Control Unit For Rear Compartment Monitor

WARNING: This page is about a different car, the 2006 BMW 760i, 2005 BMW 760i, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear compartment fresh air grill. See 64 22 190 REMOVING AND INSTALLING/REPLACING REAR COMPARTMENT FRESH AIR GRILL (AUTOMATIC A/C BASIC) and 64 22 191 REMOVING AND INSTALLING/REPLACING REAR COMPARTMENT FRESH-AIR GRILLE (AUTOMATIC A/C HIGH) .
Remove side panels on center console. See 51 16 ... REMOVING AND INSTALLING SIDE PANELS ON CENTER CONSOLE .

CAUTION:

The fully installed rear compartment monitor can only be swiveled up and down with the ignition turned on. Then turn off ignition again immediately.

Swiveling rear compartment monitor up/down without ignition voltage, refer to REMOVING REAR COMPARTMENT MONITOR .

NOTE: Follow instructions for handling optical fibers . See 61 00 ... NOTES ON HANDLING OPTICAL FIBERS .

Fold up rear compartment monitor (1).

Release screws (2) and remove trim in center console at rear (3) in direction of arrow.

Fig 1: Removing Trim In Center Console

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation:

Do not mix up plug connections (3) and (4).

Unlock plug connections (2), (3) and (4) and disconnect.

Feed out control unit for rear compartment monitor (5) in direction of arrow and set down.

Fig 2: Identifying Plug Connections & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.

Remove control unit for rear compartment monitor (2).

Fig 3: Identifying Side Trims & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out coding/programming.

Observe following IDC specifications:

Programming
Coding
Car & Key Memory
CD "CIP"

Fig 4: Identifying DIS Screen
Courtesy of BMW OF NORTH AMERICA, INC.