63 21 183 Removing and Installing/Replacing Left or Right Rear Light (From 03/2005) (On Rear Lid)

WARNING: This page is about a different car, the 2006 BMW 760i, 2005 BMW 760i, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)

Necessary preliminary tasks:

Remove rear trim See 51 13 400 REMOVING AND INSTALLING/REPLACING REAR CENTER TRIM (FROM 03/2005)

Detach trim (1) in area (A) of rear light (2) downwards.

Area (B) of trim (1) remains on vehicle.

Installation:

Ensure trim (1) is correctly seated.

Fig 1: Detaching Trim Of Rear Light

G04768774

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unscrew nuts (2).

NOTE: Secure rear light against falling out.

Fig 2: Identifying Plug Connection & Nut

G04768775

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip rear light (1) and remove.

Installation:

If necessary, replace faulty clip (2).

Make sure there is a uniform gap (outer) all round for rear lid.

Make sure sealing frame for rear light is correctly seated; replace sealing frame if necessary. See 63 21 104 REPLACING SEALING FRAME FOR LEFT OR RIGHT REAR LIGHT (UP TO 03/2005) (ON REAR LID)

Fig 3: Identifying Rear Light & Faulty Clip

G04776471

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove bulb . See 63 99 315 REPLACING BULB(S) FOR LEFT OR RIGHT REAR LIGHT (FROM 03/2005)