51 43 255 Removing and Installing/Replacing Trim For Rear Left or Right Roof Pillar (Front)

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Version with head airbag:

Follow safety instructions for working on cars with airbag systems. See 51 00 ... SAFETY INSTRUCTIONS FOR WORKING ON CARS WITH AIRBAG SYSTEMS

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Necessary preliminary tasks:

Remove trim for rear roof pillar (rear) See 51 43 251 REMOVING AND INSTALLING/REPLACING TRIM FOR REAR LEFT OR RIGHT ROOF PILLAR (REAR)

IMPORTANT: Lever out expander rivet heads (1) only over groove (3) on lower section (2). If necessary, turn lower section (2) with groove (3) towards front.

Release clip (4) and remove trim (5) towards inside/top.

Fig 1: Identifying Clip, Expander Rivet Heads & Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommet (1).

Fig 2: Identifying Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clip (1).

Bores (2) and insulating mat (4) of trim (3) must not be damaged.

Fig 3: Identifying Bores, Insulating Mat & Trim

Courtesy of BMW OF NORTH AMERICA, INC.