51 43 251 Removing and Installing/Replacing Trim For Rear Left or Right Roof Pillar (Rear)

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Version with head airbag:

Follow safety instructions for working on cars with airbag systems. See 51 00 ... SAFETY INSTRUCTIONS FOR WORKING ON CARS WITH AIRBAG SYSTEMS

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Version with head airbag in rear compartment:

If necessary, lever out airbag emblem (1) and release screw underneath.

Tightening torque 51 43 1AZ. See 51 43 SIDE TRIM PANEL WITH ARMRESTS

Release clips (2) and catches (4) from trim (3).

Pull out trim (3) towards inside at top.

Fig 1: Identifying Clips, Catches & Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommets (1).

Fig 2: Identifying Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 3: Identifying Retainer & Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) of panel (3).

Catches (2) on trim (3) must not be damaged.

Fig 4: Identifying Catches, Trim & Clips

Courtesy of BMW OF NORTH AMERICA, INC.