51 12 156 Removing and Installing Rear Bumper Trim

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Necessary preliminary tasks:

Remove trim on bumper trim See 51 12 080 REMOVING AND INSTALLING/REPLACING TRIM ON BUMPER TRIM
Remove trim on rear light See 51 13 440 REMOVING AND INSTALLING/REPLACING TRIM ON LEFT OR RIGHT REAR LIGHT

Build date up to 03/2005 only:

Remove middle body molding See 51 12 432 REPLACING CENTRAL BODY MOLDING ON REAR BUMPER

Release screws (1 and 2) on left/right.

Fig 1: Identifying Screws (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (2).

Build date up to 03/2005:

Release screws (1).

Fig 2: Identifying Screws (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Bumper trim (1) is locked at sides in mounting holder and must be unlocked for removal purposes (risk of damage).

Removing:

Insert special tool 00 9 317 at distance (A)
Disengage/unlock bumper trim (1)
Pull bumper trim (1) straight towards rear with aid of a 2nd person
If necessary, disconnect plug connections
Pull off bumper trim (1)

A = 60 mm

Installation:

Observe gap dimensions . See BODY GAP DIMENSIONS .

Fig 3: Identifying Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.