36 10 209 Checking Front and Rear Wheel For Face and Radial Runout

Special tools required: 

• 36 1 030 

Necessary preliminary tasks: 

• Check wheel bearings

Lift vehicle.

Check wheel with special tool 36 1 030  (measuring fixture) for lateral runout  . See 36 1 030 TESTER and see 36 10 WHEELS ONE-PART ALLOY WHEELS , 36 10 WHEELS STEEL AND ALUMINUM STRIP WHEELS and 36 10 WHEELS TWO-PART ALLOY WHEELS

Fig 1: Locating Lateral Runout With Special Tool (36 1 030)

Courtesy of BMW OF NORTH AMERICA, INC.

Check wheel with special tool 36 1 030  (measuring fixture) for radial runout  . See 36 1 030 TESTER and see 36 10 WHEELS ONE-PART ALLOY WHEELS , 36 10 WHEELS STEEL AND ALUMINUM STRIP WHEELS and 36 10 WHEELS TWO-PART ALLOY WHEELS

Fig 2: Checking Radial Runout With Special Tool (36 1 030)

Courtesy of BMW OF NORTH AMERICA, INC.

If applicable, remove balance weights.

Check lateral runout  of rim with special tool 36 1 030  (measuring fixture). See 36 1 030 TESTER and see 36 10 WHEELS ONE-PART ALLOY WHEELS , 36 10 WHEELS STEEL AND ALUMINUM STRIP WHEELS and 36 10 WHEELS TWO-PART ALLOY WHEELS

Fig 3: Locating Lateral Runout Of Rim With Special Tool (36 1 030)

Courtesy of BMW OF NORTH AMERICA, INC.

Check radial runout  of rim with special tool 36 1 030  (measuring fixture). See 36 1 030 TESTER and see 36 10 WHEELS ONE-PART ALLOY WHEELS , 36 10 WHEELS STEEL AND ALUMINUM STRIP WHEELS and 36 10 WHEELS TWO-PART ALLOY WHEELS

Fig 4: Locating Radial Runout With Special Tool (36 1 030)

Courtesy of BMW OF NORTH AMERICA, INC.