65 82 530 Replacing MOST CAN Gateway Control Unit

Special tools required: 

• 64 1 020 

Necessary preliminary tasks: 

• Remove control display.  See 65 82 010 REMOVING AND INSTALLING (REPLACING) CONTROL DISPLAY 

Lever out lugs (1) in direction of arrow.

Fig 1: Lever Out Lugs (1) In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Lift housing of control display (1) over catches (2) using special tool 64 1 020  . See 64 1 020 RELEASE HOOK

Fold up control display (2) in direction of arrow and feed out of MOST CAN gateway control unit (3).

Fig 2: Removing Control Display

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Do not kink ribbon cables (3) when assembling control display (2) and MOST CAN gateway control unit (1).

Fig 3: Identifying Ribbon Cables, Control Display & Control Units

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Remove MOST CAN gateway control unit (2) from control display (3).

Fig 4: Identifying Plug Connection, Control Unit & Control Display

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Carry out coding/programming.

Observe following IDC specifications:

• Programming
• Coding
• Car & Key Memory
• CD "CIP"
  Fig 5: Identifying DIS

  Courtesy of BMW OF NORTH AMERICA, INC.