61 67 083 Removing And Installing/Replacing Left Or Right High-Pressure Nozzle Of Headlight Cleaning System

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 3 010

Remove front bumper trim. See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .

To prevent excess escape of washer fluid, seal off end of high - pressure line with special tool 13 3 010.

Fig 1: Identifying Special Tool (13 3 010)

G04753639

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock H.P. line (3) and detach from H.P. nozzle (1).

Release screws (2).

Remove H.P. nozzle (1).

Fig 2: Identifying H.P. Line And H.P. Nozzle

G04768701

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide (2) into opening (1).

New spray nozzles are already preset.

Carry out function check.

Fig 3: Identifying Guide Into Opening

G04768702

Courtesy of BMW OF NORTH AMERICA, INC.