51 11 ... Installing/Replacing License Plate (Without Base)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Tightening torque: 51 11 7AZ . See FRONT BUMPER for specs.

Fit protective caps.

Fig 1: Identifying Template On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1)*.

Secure license plate (3) with license plate screw (4)*.

Tightening torque: 51 11 8AZ . See FRONT BUMPER for specs.

NOTE:

* Sourcing reference: BMW Parts Service

Fig 2: Identifying Bumper And License Plate

Courtesy of BMW OF NORTH AMERICA, INC.