37 14 610 Removing And Installing / Replacing Transversal-Acceleration Sensor
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
IMPORTANT:
Do not kink floor panelling under any circumstances!
Necessary preliminary tasks:
- Remove RIGHT FRONT SEAT
- Lift floor panelling and fold back to one side
Release screws (1).
Tightening torque 37 14 23AZ . See ELECTRICAL COMPONENTS for specs.
Disconnect plug connection.
After installation:
- If necessary, carry out initial DYNAMIC DRIVE operation.