LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1182 (Seats -- Repair Instructions) >> Front Seat, Normal, Electric >> 52 14 000 Removing And Installing Left Or Right Front Seat (Normal/Electric)

52 14 000 Removing And Installing Left Or Right Front Seat (Normal/Electric)

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

WARNING:

Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.

Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Switch off ignition!

Adjust front seat as far forward and upward as possible.

Unfasten screws.

Tightening torque: see 1AZ in 52 10 FRONT SEATS .

Fig 1: Identifying Front Seat Adjust Screws
G04742753Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) for belt mounting.

Tightening torque: see 4AZ in 72 11 SEAT BELTS .

Fig 2: Identifying Belt Mounting Screw
G04742754Courtesy of BMW OF NORTH AMERICA, INC.

Move front seat as far back as possible.

Raise bridge (1) on front right seat rail cover slightly and unlock.

Pull cover forwards to remove.

Fig 3: Identifying Bridge
G04742755Courtesy of BMW OF NORTH AMERICA, INC.

Press rocker switch (1) on front left seat rail cover and unlock.

Gently slide cover (2) towards front.

Carefully unlock inside edge (3) from inside.

Pull cover forwards to remove.

Fig 4: Identifying Rocker Switch And Cover
G04742756Courtesy of BMW OF NORTH AMERICA, INC.

Release front screws on left and right seat rails.

Tightening torque: see 1AZ in 52 10 FRONT SEATS .

Fig 5: Locating Left And Right Seat Rails Front Screws
G04742757Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Floor carpet must not project between seat rail and floor board in area of screw-down points (grinding noises).

Carefully tip seat towards rear.

Unclip cover (1) towards front.

Disconnect plug connections (yellow and black) on seat modules.

IMPORTANT:

Remove door sill with protective covers (damage to vehicle).

Lift out front seat.

Fig 6: Removing Cover
G04742758Courtesy of BMW OF NORTH AMERICA, INC.