31 35 021 Replacing Rubber Mounts Of Stabilizer Retaining Fixture On Front Axle Carrier
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove stabilizer from front axle carrier . See REMOVING AND INSTALLING/REPLACING FRONT STABILIZER and REMOVING AND INSTALLING/REPLACING FRONT ACTIVE STABILIZER .
Remove retaining bracket (1), if necessary retaining plate (3) and rubber mount (2) on both sides.
Installation:
Keep retaining bracket (1), rubber mount (2) and stabilizer clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.