31 35 000 Removing And Installing/Replacing Front Stabilizer

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT ASSEMBLY UNDERSIDE PROTECTION .
If necessary, remove wheel suspension cover on both sides
Remove STABILIZER LINK ON BOTH SIDES FROM STABILIZER .

If necessary, remove holder for hydraulic lines from retaining bracket.

Release nut (1) and screw (2) at both ends.

Remove stabilizer from front axle carrier.

Installation:

Check both RUBBER MOUNTS for damage, replace if necessary.

Replace self-locking nuts.

Tightening torque 31 35 1AZ . See 31 35 STABILIZER BAR for specs.

Fig 1: Identifying Nut And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove RUBBER MOUNT ON BOTH SIDES FROM STABILIZER .