23 14 550 Removing/replacing zero gear sensor (GS6-53BZ)
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After installing the zero gear sensor, it is necessary to teach in the position of the zero gear sensor again.
Adjustment is carried out with the "Service function" of the DIS Tester (learn/write zero gear sensor).
Adjustment is carried out with the "Service function" of the DIS Tester (learn/write zero gear sensor).
Necessary preliminary tasks:
- Lower transmission
Tasks are described in Removing TRANSMISSION .
Disconnect plug connection (1) on zero gear sensor.
Release screws (2).
Remove zero gear sensor.
Installation note:
Replace screws (2).
Tightening torque: 5 Nm