41 61 014 Adjusting Engine Bonnet/Hood

Read contents of, see BODY, GENERAL .

The specified, see BODY GAP DIMENSIONS serve as the basis for adjustment tasks.

Make unpainted surfaces visible by also moving the hinges. Touch these up in the appropriate color.

NOTE: Carry over schematic representation to the relevant vehicle type.

Loosen screws (1) and (2) on left and right hinges.

Hood lid must be able to be moved.

NOTE: If the adjustment range is not sufficient, release retaining screws of engine hood hinge on body and move hinge.

Fig 1: Hood Hinge Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Locks and retaining hook must snap correctly into place.

Adjust engine hood.

NOTE: Bump stops at engine hood to side panel by means of stop pads.

Fig 2: Locating Engine Hood/Bonnet Adjustment Area

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Height adjustment of bonnet to front wall:
Release screw (1) and remove cover (2).
Height adjustment by turning at closing hooks (3).

Fig 3: Cover, Hooks With Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down all screw connections again.

Tightening torque 18.5 Nm.

IMPORTANT: Check function of retaining hook.