41 13 510 Replacing Left Equipment Carrier Partition Wall (Wheel Arch Removed)
Read contents of see BODY, GENERAL .
The weight-reduced aluminum front end structure (GRAV) is used on this vehicle.
Observe specific procedure. See 4100... BONDING ALUMINUM ON ALUMINUM ; 4100... RIVETING ALUMINUM PARTS ; 4100... MATERIALS SCIENCE ; 4100... EMC SCREWS ; 4100... STRAIGHTENING ALUMINUM PARTS or 4100... GRINDING ALUMINUM PARTS .
Following new body parts are required (refer to EPC):
- (1) Complete partition wall reinforcement
- (2) Shaped part, partition wall, equipment compartment (not shown)
Open rivet joints in areas (1) to (3).
Open, see EMC WELD SEAM in area (5).
Installation:
Use 4 rivets (size 13) in area (1).
Use 1 rivet (size 13) in area (2).
Use 1 rivet (size 13) in area (3).
Use 1 rivet (size 13) additionally in area (4).
Use 2, see EMC SCREWS additionally in area (1).
Open rivet joints in areas (1) and (2).
Open, see EMC WELD SEAM in area (3).
Installation:
Use 3 rivets (size 13) in areas (1).
Use 4 rivets (size 13) in area (2).
Use 2, see EMC SCREWS additionally in area (2).
Carry over holes for rivets to new part.
Adjust new part together with wheel arch to fit and secure.
Drill through both parts together.
Stick on, see CAVITY ACOUSTIC BAFFLE all round with window glass adhesive in area (4).
see BOND new part.
see RIVET new part.