12 42 500 Removing And Installing Or Replacing Battery Positive Lead (Between Alternator, Starter Motor And Jump Start Connection Point) (N62, N62TU)
REFERENCE CHART
| Work step | Note: |
|---|---|
| Switch off ignition | |
| Disconnect battery negative lead | Follow instructions for disconnecting and connecting battery |
| Disconnect battery positive lead at jump start connection point | Tightening torque: 12 42 1AZ . See WIRES TO STARTER for specs. |
| Remove INTAKE AIR MANIFOLD | |
| Remove FAN COWL | |
| Detach battery positive lead from alternator | |
| Release expansion tank | |
| Secure engine in installation position with special tool | |
| Release both engine mounts from above | |
| Lower front axle | |
| Remove right exhaust manifold | |
| Remove HEAT SHIELD FROM STARTER MOTOR | |
| Detach battery positive lead from starter motor | Tightening torque: 12 41 4AZ . See STARTER AND MOUNTING PARTS for specs. |
| Remove battery positive lead |