12 42 500 Removing and installing or replacing battery positive lead (between alternator, starter motor and jump start connection point) (N62, N62TU)
WORK STEP CHART
| Work step | Note: |
|---|---|
| Switch off ignition | |
| Disconnect battery negative lead | Follow instructions for disconnecting and connecting battery |
| Disconnect battery positive lead at jump start connection point | Tightening torque 12 42 1AZ . See 12 42 WIRES TO STARTER . |
| Remove intake air manifold . See 11 61 050 REMOVING AND INSTALLING INTAKE AIR MANIFOLD (N62) . | |
| Remove fan cowl . See 17 11 035 REMOVING AND INSTALLING/REPLACING FAN COWL WITH ELECTRIC FAN (N62, N62TU) . | |
| Detach battery positive lead from alternator | |
| Release expansion tank | |
| Secure engine in installation position with special tool | |
| Release both engine mounts from above | |
| Lower front axle | |
| Remove right exhaust manifold | |
| Remove heat shield from starter motor | |
| Detach battery positive lead from starter motor | Tightening torque 12 41 4AZ . See 12 41 STARTER AND MOUNTING PARTS . |
| battery negative lead |
Unclip battery positive lead (2) from holders (1).Installation: Make sure battery positive lead is in correct installation position. Danger of short circuits.
Add final details to vehicle. Check function of DME.