51 16 211 Removing and installing/replacing finisher for storage tray
Necessary preliminary tasks:
- Remove KNOB FOR CONTROLLER
- Remove BUTTON UNIT
Version with manual transmission:
- Remove GAITER for gear lever.
Version with automatic transmission or SMG:
If necessary, remove ashtray insert.
Release screws (1).
Open center console cover.
Press release button for center console cover and release trim (2) from catches (4).
Feed trim (2) towards top/rear out of storage compartment (3).
If necessary, disconnect plug connections on insert at front.
Security version:
Disconnect plug connection on INTERCOM SYSTEM SWITCH .
Installation:
Following parts of trim (4) must not be damaged or missing:
- Front insert
- Retaining lugs
- Pins or spring clips
Replacement:
Remove FRONT INSERT (1) .
Replacement with Security version:
Remove INTERCOM SYSTEM SWITCH