51 43 255 Removing and installing/replacing trim for rear left or right roof pillar (front)

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Necessary preliminary tasks:

Detach expansion rivets (1) and clips (2) from trim (3). Pull out trim (3) inwards/upwards.

Installation:

If necessary, replace faulty clips (2) or expansion rivets (1).

Fig 1: Pulling Out Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (2) must not be damaged or missing:

1 Insulating mat
3 Bores
4 Grommet
5 Retainer

Fig 2: Identifying Insulating Mat, Grommet And Retainer
Courtesy of BMW OF NORTH AMERICA, INC.