51 43 251 Removing and installing/replacing trim for rear left or right roof pillar (rear)

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Lever out airbag emblem (1) and release screw underneath.

Installation:

Tightening torque 51 43 1AZ . See 43 SIDE COVERING WITH ARMRESTS .

Unclip clip (3) and clips (4) of trim (2) and pull out trim (2) inwards and upwards.

Fig 1: Pulling Out Trim Inwards And Upwards

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 2: Identifying Retainer On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (4) must not be damaged or missing:

Clip
Guide
Clips

Fig 3: Identifying Trim Clips And Guide
Courtesy of BMW OF NORTH AMERICA, INC.