3112080 Removing and installing/replacing both tension struts

Necessary preliminary tasks

Release nut (1); if necessary, grip at Torx socket.

Installation:

Keep tension strut to swivel bearing connection clean and free from oil and grease.

Replace self-locking nut.

Tightening torque, see 31 12 2AZ in 31 12 CONTROL ARMS AND STRUTS .

Fig 1: Identifying Tension Strut Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1) and remove tension strut.

Raise locking nut (2) in area of bore and detach from front axle support.

Installation:

Replace locking nut.

Tighten bolt connection in NORMAL POSITION .

Tightening torque, see 31 12 1AZ in 31 12 CONTROL ARMS AND STRUTS .

Fig 2: Identifying Tension Strut Bolt And Front Axle Support Nut

Courtesy of BMW OF NORTH AMERICA, INC.