51 16 210 Removing And Installing/Replacing Trim For Preselector Lever
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Risk of damage!
When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.
Necessary preliminary tasks:
- Remove gaiter for shift tower . See 51 16... Removing And Installing/Replacing Trim For Gearshift
- Depending on equipment specification: Remove controller. See 61 31 195 REMOVING AND INSTALLING (REPLACING) FRONT CONTROLLER (UNTIL 9/08) or 61 31 195 REMOVING AND INSTALLING (REPLACING) FRONT CONTROLLER (FROM 9/08)
Pull trim (1) upwards and thereby release from clamps (2) and latch mechanisms (3).
Installation note:
Cables must not be jammed.
Clamps (2) and latch mechanisms (3) must not be damaged.
If replacing with controller version: Provide trim (1) with recess (2) for controller (3).
NOTE:
Recess (2) is marked on the underside of the trim (1).