61 31 195 Removing And Installing (Replacing) Front Controller (Until 9/08)

WARNING: This page is about a different variant/trim than selected.

Special Tools Required

Necessary preliminary tasks:

IMPORTANT:

Risk of damage!

Install knob for controller only when controller is installed.

Lever gaiter (1) out of center console with special tool 00 9 317 and slide upwards.

Fig 1: Identifying Lever Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Press cable retaining plate (1) downwards to gain access to controller from below.

Fig 2: Pressing Cable Retaining Plate

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Sharp edges on center console and on cable ties may cause injury.

Carry out this operation with care.

Insert hand between cable retaining plate (3) and center console (2).

Press controller (1) upwards out of catch.

Disconnect associated plug connection and remove controller (1).

Fig 3: Removing Controller

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove controller (2) from trim (3).

Fig 4: Removing Controller & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainers (1) of controller (2) must not be damaged or missing.

Fig 5: Identifying Retainers Of Controller

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding.