51 11 050 Removing And Installing/Replacing Carrier For Front Bumper Trim

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: Description is shown on the E82 by way of example. There may be differences in detail in the case of other models.

IMPORTANT: During replacement, all the cavities of the carrier (1) and the crashbox (2) must be sealed with cavity sealant.

Fig 1: Identifying Carrier & Crashbox

Courtesy of BMW OF NORTH AMERICA, INC.

Version with brake air duct:

Release screw (1) on cooling air guide (2) on left/right.

Remove cooling air guide (2).

NOTE: The following work step ends here: "Removing and installing brake air duct".

Fig 2: Identifying Cooling Air Guide & Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Depending on version:

Release screws (1) on carrier (2).

Remove shock absorbers (3) on left/right.

Release washer fluid hose (4) from carrier (2).

Fig 3: Identifying Carrier, Absorbers & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, disconnect plug connections (1) on fanfare horn.

Release blind rivets (2) on left/right.

Release nuts (3) on left/right.

Tightening torque, see 51 11 2AZ in 51 11 FRONT BUMPER .

If necessary, remove fanfare horn holder (4).

Remove carrier (5).

Installation:

Blind rivets (2) are only required for fitting in the factory and do not have to be refitted.

Fig 4: Identifying Plug Connections, Fanfare Horn Holder, Nut & Rivets

Courtesy of BMW OF NORTH AMERICA, INC.