61 31 192 Replacing Knob For Controller

WARNING: This page is about a different variant/trim than selected.

Special Tools Required

00 9 317 TRIM PANEL WEDGE

IMPORTANT: Before dismantling the button it is imperative to note whether the controller is installed with a version before or after 09/2008!

NOTE: The number of buttons and shape of controller can vary depending on vehicle type. Before 09/2008: Controller (1) has buttons on bottom only. After 09/2008: Controller (2) has buttons top and bottom. Button may be removed from controller (1) only!

Fig 1: Identifying Number Of Buttons And Shape Of Controller

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: These repair instructions describe the removal of the button from controller (1)!

Partially fit special tool 00 9 317 as illustrated.

Lever out knob for controller (1) in direction of arrow and pull off.

Fig 2: Identifying Controller

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Risk of damage!

Install knob for controller only when controller is installed.

Installation:

Fit knob for controller (1) so that guides (2) are correctly seated in mountings (3).

Press knob for controller (1) in middle until it engages.

Fig 3: Identifying Controller & Guides

Courtesy of BMW OF NORTH AMERICA, INC.