61 13... Removing And Installing/Replacing OBD-II Socket

Special Tools Required 

• 61 0 315 

Necessary preliminary tasks: 

• Remove footwell side trim panel on A-pillar, left  . See 51 43 070 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, LEFT .

Release screws (1).

Remove OBD-II socket (2) from holder (3).

Fig 1: Removing OBD-II Socket Of Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove OBD-II socket cover (2) from OBD-II socket (1).

Unlock slide plate (3) with a suitable tool in direction of arrow.

Insert special tool 61 0 315  in OBD-II socket (1) in direction of arrow and press out associated flat spring contact (4). Press remaining flat spring contacts with special tool 61 0 315  out of OBD-II socket (1).

Installation: 

Pay attention to pin assignment of OBD-II socket (1).

Make sure flat spring contacts and slide plate (3) are correctly engaged and seated in OBD-II socket (1).

Fig 2: Removing OBD-II Socket & OBD-II Socket

Courtesy of BMW OF NORTH AMERICA, INC.