51 43 070 Removing And Installing/Replacing Side Trim Panel, Footwell, On A-Pillar, Left

Necessary preliminary tasks: 

• Remove front entrance   cover strip (inside) 
• Remove trim panel for pedal assembly .

Detach mucket (1) in area of side trim panel (2).

Release screw (3).

Remove hood/bonnet release lever (4) from side trim panel (2).

Fig 1: Identifying Side Trim Panel, Mucket & Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Unclip side trim panel (3) in direction of arrow from retaining points (2).

If necessary, disconnect associated plug connection and remove side trim panel (3).

Fig 2: Identifying Trim Panel & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clips (1).

Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Replacement: 

Remove switch for unlocking  rear lid   .

Fig 3: Identifying Trim Panel, Claws & Screws

Courtesy of BMW OF NORTH AMERICA, INC.